Heat Trak Accessories

Heat Trak has aligned itself with leading manufacturers of snow sensors and temperature controls to help the customer fully automate the HeatTrak® products.

Thermostat (EH 38, manufactured by EasyHeat); 120V, 15 Amps

The EH38 plugs directly into any 120V outlet, and then acts as an outlet receptacle itself. Once the EH38 is plugged in, a HeatTrak® mats can plug directly into the back of the EH38 thermostat. When installed, the convenient EH38 automatically energizes the mat at temperatures lower than 38_F/ 3_C and then shuts off power when the temperature rises to 50_F/10_C. The EH38 has a power indicator light that lights up when the thermostat is energized. The EH38 is designed only for 120V products, and can handle up to 15 Amps.
Cost $30.00

Snow & Temperature Sensor (LCD-1, manufactured by ETI);120V/240V, 16 Amps

The LCD-1 snow switch is an energy saving alternative to thermostat, manual or timer controls. The LCD-1 operates the HeatTrak® mats when precipitation occurs at temperatures below 38_F (3.3_C) and remains energized for 5 hours after precipitation stops to ensure complete ice/snow melting. The LCD-1 snow switch operates from 120Vac, 50/60 Hz. An integral relay rated for 120/240Vac 16 Amp loads permits direct heater control for small applications such as wheelchair ramps and stairways or may operate external contactors in large installations. The LCD-1 is hardwired into a circuit and is not a plug-and-play like the EH38. For best results, the LCD-1 should be mounted at least six feet off the ground with nothing hanging over it (i.e. an overhang, awning, etc.).
Cost $204.00

Snow & Temperature Control System for Large Applications (CIT-1 & APS-3B, manufactured by ETI)

The CIT-1/ APS-3B combination is meant for large applications of HeatTrak® products. The CIT-1 is a snow and moisture sensor that is mounted at least six feet off the ground (with no overhang above it). The CIT-1 connects to the APS-3B controller through standard outdoor electrical conduits (not provided by HeatTrak), which is mounted on the side of the building near the application. Many circuits can then be wired into the controller to energize multiple mats that may lie on the circuit. CIT-1 APS-3B Total
Cost $339.00 $975.00 $1,314.00